AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateHVAC Company in Irving, TX
Furnace repair in Irving means working on two different cities at once. Older ranches near the Heritage District run first-generation gas furnaces and heat pumps that need real diagnosis, while the towers and hotels around Las Colinas run packaged rooftop units, VRF systems, and vertical-stack equipment that need a technician who knows them by name. Add DFW hard freezes that expose weak ignition parts and failing reversing valves, and you get a heating season that keeps Irving technicians sharp. We repair what you already own before anyone mentions replacement. Call (844) 761-3596 and we’ll get a technician out. We answer 24/7 with fast dispatch from 7am to 7pm, Sunday through Friday.
Why Irving Homes Are Different
Irving splits into two housing worlds, and each asks something different of an HVAC technician. On the older side, 1950s to 1970s single-family ranches and small brick cottages sit on pier-and-beam or slab in the Heritage District and south Irving, many with original or first-replacement central systems tucked into undersized closets. Attic ductwork in those homes is often cramped and aging, which makes a changeout or a duct repair a tighter job than it would be in newer construction. On the other side, Las Colinas and the 75038 and 75039 corridors are dense with apartments, condos, hotels, offices, and mid- and high-rise towers. Those rely on vertical-stack or water-source heat pump systems with small equipment rooms that leave little room to work. The climate ties both sides together: long summers that hammer the air-conditioning load, spring and summer humidity that punishes leaky ducts, and enough winter cold snaps and hard freezes to expose weak ignition parts and emergency-heat failures. Severe storms with hail, wind, and power interruptions around DFW Airport knock out capacitors, control boards, and condenser fans on both commercial rooftops and residential condensers. One operator has to handle low-rise single-family retrofits and commercial-grade service, and that mix is not what most neighboring suburbs demand.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Our Main Irving Services
Most Irving homeowners call us about two things: a system that has stopped cooling in the heat, and a system that needs replacing after one too many summers. Here’s how each job actually goes in Irving.
AC Repair in Irving
AC repair in Irving starts with a real diagnosis: refrigerant charge, capacitor and contactor condition, airflow, and the ductwork feeding each room. In the older ranches near the Heritage District, we often find attic duct runs that have lost insulation or pulled loose at a collar, which pushes the compressor to work harder than it should. Around Las Colinas, the calls tend to be vertical-stack and water-source units with tight equipment rooms and access panels that need careful handling. Storm surges from DFW-area weather leave capacitors and control boards as common failures. We work on the brand you already have and default to fixing it. For a closer look, see AC Repair in Irving.
AC Installation in Irving
AC installation in Irving is scheduled work, not same-day work: we size the system to the house, confirm what the existing ductwork can actually handle, and set an install date. Older south Irving homes with undersized closets and first-generation slab work sometimes need duct and closet adjustments before new equipment goes in, and we plan those up front rather than discovering them mid-job. High-rise and condo installations in Las Colinas bring their own constraints around vertical-stack access and equipment-room clearances. You get a written fixed price before anything is ordered. For the full scope, see AC Installation in Irving.
Furnace Repair in Irving
Furnace repair in Irving runs the range from gas furnaces in 1960s south Irving ranches to heat pumps and vertical-stack units in the Las Colinas corridors, and the heating season here is short but sharp: hard freezes around DFW Airport expose weak igniters, failing pressure switches, and reversing valves that never had to prove themselves in milder winters. That’s where Furnace Repair starts, with a technician who can read your system before touching a part. Our technicians have up to 15 years of experience across nine of the most widely installed residential brands, including Daikin, Bryant, American Standard, and Carrier, so nothing on your equipment is a guess. We fix what you have rather than steering you toward a new system, and the written estimate sets the price before any work begins.
Gas Furnace Repair
Signs you need it
You smell gas near the unit, hear the igniter click without flame, or the furnace trips its limit switch and shuts off mid-cycle.
What it costs in Irving
Gas furnace repair in Irving typically runs $150 to $700, with the written estimate setting the final price once the actual fault is found.
How we do it
We shut the gas, test the igniter, flame sensor, pressure switch, and heat exchanger, then repair or replace only the failed components and verify combustion.
Heat Pump Repair
Signs you need it
The system blows cool air in heating mode, the reversing valve sticks, or the outdoor unit ices over and won’t defrost.
What it costs in Irving
Heat pump repair in Irving typically falls in the $150 to $700 range, and the written estimate pins the exact figure before work starts.
How we do it
We check refrigerant charge, test the reversing valve and defrost board, inspect the outdoor fan and contactor, and cycle the system through both modes.
Heating Repair
Signs you need it
The house never reaches the set temperature, the blower runs constantly, or the system short-cycles through the night.
What it costs in Irving
Heating repair in Irving generally runs $150 to $700, with the written estimate fixing the price once the cause is confirmed.
How we do it
We measure airflow and temperature rise, test the thermostat and control board, inspect the blower and duct connections, and repair what’s actually failing.
What Furnace Repair Costs in Irving
| Item | Typical range in Irving |
|---|---|
| Gas furnace repair | $150 – $700 |
| Heat pump repair | $150 – $700 |
| Heating repair | $150 – $700 |
Can you repair a gas furnace in Irving the same day?
Often, yes. If you call during dispatch hours, we can typically get a technician to most Irving addresses the same day, and the diagnosis and written estimate come first. Call (844) 761-3596. We answer 24/7 with fast dispatch from 7am to 7pm, Sunday through Friday.
Should I repair or replace my furnace in Irving?
Repair first, unless the heat exchanger is cracked, the unit is failing repeatedly, or the repair bill approaches replacement cost. We diagnose honestly and give you the options; the decision is yours, and there’s no pressure toward a new unit. Call (844) 761-3596 for a free estimate.
Brands We Service in Irving
We work on the brand you already have. Our technicians are factory-familiar with Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard, which covers most of what’s installed in Irving homes and the systems we see in Las Colinas towers. We don’t claim to stock parts; we diagnose first, then source what’s needed for the repair. For a plain rundown of what we handle, see our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for HVAC Company in Irving, TX
| Service | Typical range in Irving |
|---|---|
| AC repair | $150 – $650 |
| Furnace repair | $150 – $700 |
| AC installation | $3500 – $7500 |
| Tune-up | $80 – $200 |
What pushes price up in Irving is usually access and condition: undersized closets and attic duct runs in older south Irving homes make a straightforward repair take longer, and high-rise equipment rooms in Las Colinas add labor to any job. Installation climbs toward the top of the range when duct and closet adjustments are part of the changeout. The written estimate sets the final price before work starts, and the estimate itself is free.
Neighborhoods We Serve in Irving
We cover the whole city, from the older single-family blocks to the tower corridors. Response times are similar across the map during dispatch hours, though high-rise access and parking in Las Colinas can add a few minutes once we’re on site. If your system is down in a freeze or a heat wave, call early in the day and we’ll work you into the schedule. Areas we serve regularly include:
- Heritage District
- South Irving
- Las Colinas
- The 75038 and 75039 corridors
- Neighborhoods around DFW Airport
Service Area – Cities Near Irving
Irving sits in the middle of the Metroplex, and we cover the neighboring cities too. If you’re just outside Irving, we can still get a technician to you: check our pages for Carrollton, TX, Dallas, TX, Grand Prairie, TX, and Lewisville, TX. Each city has its own housing mix and climate stresses, and the diagnostic approach carries over cleanly from Irving.
Serving Irving, TX – Our Local Coverage Area
We serve Irving and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About HVAC Company in Irving
During dispatch hours we can typically reach most Irving addresses the same day, and we answer the phone 24/7 so you can get on the schedule as soon as possible. Call (844) 761-3596 for a free estimate.
Most HVAC replacements require a permit from the city, and some HOAs, especially in Las Colinas and the newer corridors, require approval before exterior equipment changes. Ask your HOA and the Irving building department before work starts; we’ll tell you what’s typically involved.
We cover the entire city, from the Heritage District and south Irving to Las Colinas and the 75038 and 75039 corridors, plus the neighborhoods around DFW Airport. If you’re not sure whether your address falls in range, call (844) 761-3596 and we’ll confirm.
If your furnace is struggling or your AC has quit, the fastest path is a call. Reach us at (844) 761-3596 for a free estimate. We work on the brand you already have, repair before we replace, and keep both heating and cooling covered under one company name. We answer 24/7 with fast dispatch from 7am to 7pm, Sunday through Friday.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local HVAC pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically within 30-60 min.
- 4You approve before work beginsNothing starts until you say go.
What Irving Customers Say
"Blower motor on a 12 year old furnace. He gave me the honest math on repair versus replace and did not push me toward the bigger ticket. We repaired it and it's been fine."
- Hector Morales"Ductwork in the attic had a disconnected run that had been dumping cold air into the insulation for who knows how long. He found it, resealed it, and one bedroom that was always hot is now normal."
- Alejandro Flores"AC died in August, which in this city is an emergency. He found a blown capacitor, replaced it, and had cold air blowing in under 40 minutes. Charged me about what I'd expect to pay for the part plus a service call."
- Javier Guzman